Profile Heat Shrink Wrap

The Heat Shrink Wrap from Profile Design is a minimalist, lightweight alternative to handlebar tape and has been specially developed for the hand contact surfaces on aerobars and aero base handlebars.

Attachment is similar to that of a shrink sleeve: Heat shrinks the Heat Shrink Wrap so it adapts precisely to the shape of the handlebar and aerobars. The previously applied double-sided adhesive strips ensure that everything stays in place. The 50 cm long Heat Shrink Wrap can be cut into four equal lengths of 12.5 cm each and is then sufficient for the hand contact surfaces on both the base handlebar and the aerobars.

Details:
• Minimalist alternative to handlebar tape
• Especially for the hand contact surfaces on aerobars and basic handlebars
• Very low weight compared to handlebar tape
• Attachment similar to shrink sleeve
• Adapts precisely to the shape of the tubes when exposed to heat
• Is sufficient for hand contact surfaces on the base handlebars and aerobars

Technical details:
• Dimensions: approx. 50 x 5.5 cm
• Shrinkage ratio under the influence of heat: 1:8

In the box:
• 1 Profile Design Heat Shrink Wrap
• 1 double-sided adhesive tape


Tip:
In addition to scissors, you will also need a hairdryer or heat gun for installation. Please follow the installation instructions.



Manufacturer: Profile Design LLC, 2677 El Presidio Street, Long Beach, California 90810, USA, www.profile-design.com
Responsible person: Grofa Action Sports GmbH, Otto-Hahn-Str. 17, 65520 Bad Camberg, Germany, www.grofa.com/de/contact-de/