Litemove AEW-230 E-bike Headlight with High Beam Function

With the AEW-230, LITEMOVE presents a powerful front light for e-bikes that is particularly impressive on MTBs. In addition to the 170 lux low beam, the front light has a switchable high beam that can be operated using the wired handlebar switch.

If you activate this, you get up to 230 lux illuminance. This is bright enough to find your way safely even in the darkest night and on the trail. The excellent visibility allows you to ride with foresight. But the AEW-230 front light not only shines far, it also shines wide. With an illumination width of up to 10 m and homogeneous light distribution, you gain a good overview and can navigate safely through the dark.

Details:
• Powerful e-bike front light with switchable high beam
• Homogeneous and wide low beam with up to 170 lux lighting power 
• High beam can be switched on with up to 230 lux (handlebar switch)
• MTi PRO lens for even light distribution
• Lighting width of up to 10 m
• Aluminium housing for excellent cooling and high durability
• Handlebar mount included
• According to German road traffic regulations (StVZO) approved for electric bikes limited to 25 km/h

Technical details:
• Material: aluminium, plastic
• Installation: handlebar mount (Ø 31.8 mm / 35 mm)
• Clamp diameter handlebar switch: Ø 22.2 mm 
• Power supply: from 9 to 16 volts direct current*
• Power consumption: 7.3 W (low beam), 15 W (high beam)
• Lamp: LED
• Lighting power: up to 170 lux (low beam), up to 230 lux (high beam)
• Light modes: dipped beam, full beam
• Dust- and waterproof in accordance with IP56
• Dimensions: approx. 63.1 x 49.9 x 52 mm
• Cable length: approx. 1400 mm (power connection), approx. 300 mm (handlebar switch connection cable)
• Weight: approx. 165 g

In the box:
• 1 LITEMOVE AEW-230 e-bike front light
• 1 high beam switch incl. connection cable
• 1 handlebar mount


*Note:
The front light is compatible with a direct current power source (DC) of 9 to 16 volts. Some e-bikes can provide this, but NOT all do!
The light connection of your drive system must provide a rated power of at least 15 watts to operate the headlight. 
For the exact voltage supply of your e-bike lighting system, please check beforehand with the respective manufacturer.
NOT suitable for dynamo!
NOT approved for e-bikes with a speed above 25 km/h or speed pedelecs!
The connection cable of the front light has two open cable ends. Depending on the e-bike drive, these can be connected to the motor of your e-bike either directly or using a separately available, manufacturer-specific plug.

Tip:
You can find a replacement handlebar mount for the LITEMOVE AEW-230 headlight under prod. code: 1612220001.

Matching LITEMOVE e-bike rear lights at ROSE:
• LITEMOVE TS-RK e-bike rear light for rear racks 50 mm (prod. code: 1612250001)
• LITEMOVE TS-RK e-bike rear light for rear racks 80 mm (prod. code: 1612260001)
• LITEMOVE TSV e-bike rear light (prod. code: 1612240001)
 

Manufacturer: Litemove, No. 198, Fuya Road, Taichung 40762 , Taiwan, , www.lite-move.com
Responsible person: Litemove Europe c/o futurelectric GmbH, Weissenbrunner Hauptstr. 2, 91227 Leinburg, Germany, info@lite-move.com