GripGrab PACR WATERPROOF GRAVEL SHOE COVERS

The PACR WATERPROOF GRAVEL SHOE COVERS by GripGrab PACR are precision-engineered for performance-driven cyclists who need reliability on demanding terrain and in unpredictable weather conditions. They are made from a stretchy neoprene material mix and feature clever INTELLISEAL technology and waterproof seams to keep your feet warm and dry. The overshoe's reinforced toe cap provides protection and resistance in tough terrain, while the abrasion-resistant tread and crank abrasion protection ensure wear resistance, even on the toughest trails.

Details:
• Wind- and waterproof unisex gravel shoe covers
• From the performance-oriented PACR series
• Produced with neoprene for good insulation
• INTELLISEAL technology for even greater water resistance
• Fully waterproof seams
• Reinforced toe box for additional protection
• With crank abrasion protection against wear
• Abrasion-resistant tread builds a robust layer on the sole
• Slim fit
• Reflective design elements

ATTENTION: Please note that despite the waterproof nature of the material, moisture may enter through the cutout on the sole of the overshoes!

Material: 81% elastodiene, 15% polyamide, 4% aramid

Technical details:
• Neoprene thickness: approx. 3 mm
• Hand wash only
• Do not bleach, do not wring out, do not tumble dry, do not iron

In the box:
• 1 pair of GripGrab PACR WATERPROOF GRAVEL SHOE COVERS

Highlights & Technologies:

PACR:
This is performance-orientated cycling clothing for experienced cyclists who demand a high level of specific functionality and strive for high-intensity performance. The clothing usually has a race fit, which means it is close-fitting for efficiency and aerodynamics.

INTELLISEAL:
IntelliSeal is a technology that significantly improves the durability and water resistance of overshoes. The rubberised binding on the underside of the overshoe acts as an elasticated seal that allows the overshoe to fit snugly to the bottom of the shoe. It reduces the tendency of overshoes to get wet on the inside due to the suction effect at the lower end. The coating also increases the abrasion resistance of the underlying material and the seam.


Manufacturer: GripGrab ApS, Literbuen 11, 2740 Skovlunde, Denmark, www.gripgrab.com